1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
4-11
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
10. Press [ ] or [ ] to select <OPTIONAL
SETTING>, then press [OK].
11. Press [ ] or [ ] to select <ON>, then press
[OK].
12. Press [ ] or [ ] to select <LONG DISTANCE>,
then press [OK].
13. Press [ ] or [ ] to select the most effective
transmission option, then press [OK].
<DOMESTIC>: Normally select this option.
<LONG DISTANCE 1-3>: Select one of these options when you make
an international call. If errors occur during fax transmissions, try the
setting from <LONG DISTANCE 1> through <LONG DISTANCE 3>.
14. Press [ ] or [ ] to select <TX SPEED>, then
press [OK].
15. Press [ ] or [ ] to select the sending speed
(33600 bps, 14400 bps, 9600 bps, or 4800 bps),
then press [OK].
If transmission errors occur frequently, lower the speed.
16. Press [ ] or [ ] to select <ECM>, then press
[OK].
17. Press [ ] or [ ] to select <ON> to reduce
system and line errors while sending to or
receiving from other machines that support
ECM, then press [OK].
To register another one-touch key or coded dial code, repeat the
procedure from step 4.
18. Press [Stop/Reset] to return to the standby
mode.
Registering E-Mail Addresses
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <ADDRESS BOOK
SET.>, then press [OK].
3. Press [ ] or [ ] to select <1-TOUCH SPD
DIAL> or <CODED SPD DIAL>, then press [OK].
To Next Page
