Canon ImagePress C700 - Learning Path for Systems Engineers; Certification

Canon
Canon imagePRESS C800/C700 Service Guide
4. Learning Path for Systems Engineers
This learning path is a comprehensive group of blended learning
programs, which will prepare the new systems engineer to setup and
service the imagePRESS C800/C700 Series devices.
Depending on the configuration of the imagePRESS C800/C700 the
systems engineer should complete either or both the imagePRESS
C7000VP Systems Training Program (EFI Controller based) or PRISMA
Systems Training Program (PRISMAsync Controller based).
Table 15 – Required Courses for Technicians with imagePRESS C7000VP Series
Certification
Course Name
Course Code
2
imagePRESS C7000VP Systems / EFI Controller Based
Online Training
09IPCIP7S00O
imagePRESS C7000VP Systems / EFI Controller Based
Classroom Training
09IPCIP7S11C_DUP
PRISMAsync Online Training
091PC7010VPS00O
PRISMAsync Classroom Training
19IP7010VPSS01C
2 Item Numbers and Part Numbers are subject to change without notice.
B. Certification
• imagePRESS C800
• imagePRESS C700
The successful completion of the imagePRESS C800/C700
Blended Training programs and passing of the final assessment exam are
required to sell this product.
imagePRESS C7000VP Systems /
EFI Controller Based Blended
Training
Online Course
(09IPCIP7S00O)
and
5-Day Classroom Course
(09IPCIP7S11C_DUP)
Non-Certified
Systems
Engineer
PRISMAsync Blended Training
Program
Online Course
(091PC7010VPS00O)
and
5-Day Classroom Course
(19IP7010VPSS01C)
Either or Both
Canon imagePRESS C800/C700 Service Guide October 2014
Revision 2 Page 35