Canon imagePRESS V900/V800/V700 Customer Expectations Document
Revision 2 imagePRESS V900/V800/V700 Customer Expectations Document Page 139
15.6 Note for Customers Who Cut Their Own Paper
Customers who cut their own paper may experience:
• An increase of paper dust in the machine
• Shortening the life of the machine’s fixing rollers due to excessive wear from the
rough side of the cut paper
• Paper jams due to paper dust getting into areas of the machine where it is not
meant to be
• Improper paper feeding
• Paper registration inaccuracies
Follow the precautions below to minimize the above issues:
• Have a process in place to regularly make sure that the cutting blades are
sharpened, and that cuts are made as clean as possible.
• Place the paper with the factory mill cut sides facing to the right (leading edge),
and to the front of the machine.
• Pay special attention to the paper grain orientation when cutting it. For more
information on paper grain, see “Paper Grain and Curl,” on p. 138.
• The best results for consistency and front to back registration are obtained by using
factory mill cut, digital compatible paper.
15.7 Media Sizes and Feed Location Chart
As with all Canon copiers, certain feed locations within the device are capable of
feeding specific media sizes, types, and weights.
When considering media, make sure the media is within the proper size and weight
parameters of the feed location. Once the desired media is selected, select the
appropriate feed location.
To Next Page
Loading...
Need help?
General
