10
1
Tap OK.
Tap Manual.
2
Open the top cover and lift the release
lever.
Important
• Do not touch the linear scale (A),
carriage shaft (B), or ink tube stabilizer
(C). Touching them may cause damage.
ACB
3
Insert the paper for adjustment between the platen (A) and paper
retainer (B) in portrait orientation with the printed side of the paper
facing up. Only one sheet of paper is needed.
A
B
When using the TX-2000 without the printer stand
Important
• Check that there is nothing under the printer.
If there is anything under the printer, it may cause scratches on
the paper or paper jams, and you might not be able to adjust
the print head correctly.
4
Load the paper aligned with the paper
alignment lines (A) to ensure that the
paper is not crooked, and align the
leading edge of the paper with the front
side of the line (B).
A
B
5
Lower the release lever to lock the paper
and close the top cover.
6
The screen for selecting the paper type
appears. Tap the type of paper you
loaded.
In this case, tap Coated papers then
Coated papers.
Note
• If The paper is loaded askew. appears,
repeat steps 2 to 5.
Load the paper for adjustment.
Load the Paper
To Next Page
Loading...
Need help?
General