Canon imagePROGRAF TX-4000 - Print Head and Ink Tank Precautions; Printer Moving Safety

3
• When using the stand
-> Assemble the stand on which you will install the printer by referring to the
Printer Stand Setup Guide (separate manual)
.
• When not using the stand
-> Proceed to
"Install the Printer"
.
Assemble the Stand
1
Attach the rod for aligning the printer to the stand.
When using the basket included with the stand When using the stacker
1. Prepare the basket rod (cord side).
2. Hook the basket rod onto the supporting plates of the stand legs.
Attach such that the protrusions (A) on the basket rod are facing
towards you.
A
1. Open the stacker box and take out rod 2.
2. Hook rod 2 onto the supporting plates of the stand legs. Attach
such that the holes (A) on rod 2 are facing up.
A
A
Attach the Alignment Rod
1
Remove the packaging material.
2
Remove all of the tape and other packaging material. Open the top
cover (A) and output guide (B), and then remove the tape afxed to
the roll holder.
A
B
Install the Printer