2-1
imagePROGRAF HDI Driver Guide
Printing
Chapter 2 Printing
This section describes how to execute a print job with the HDI driver.
The description below uses printing with the AutoCAD 2004 as an example.
Printing Procedure
1. Start AutoCAD and open the image file.
2. Select Plot from the File menu.
The Plot dialog box opens.
3. On the Plot Device sheet check the Name setting under Plotter configuration and confirm
that W6400PG (the name of the printer you use) is displayed.
4. Click the Properties button.
The Plotter Configuration Editor dialog box opens.
• If any other printer name is selected, select the name of the printer that
you want to use from the Name list.
• The names of the printers installed when the HDI driver was installed are
in the Name list.
Note
To Next Page
Loading...
