3-8
imagePROGRAF HDI Driver Guide
Setting Up a Print Job
Between Pages presents the following items for selection.
2. If the ink is running or smearing on the printed output, from the Between Scans list under
Drying Time select a time for the ink to dry between scans during printing.
Between Scans presents the following items for selection.
3. Click the OK button.
Roll Paper Margin for Safety
If the printed image appears rough or scratched by the printhead, adjust the settings for
Near End Margin and Far End Margin.
1. In the Media Detailed Settings dialog box select a setting from the Near End Margin list
under Roll Paper Margin for Safety.
Near End Margin presents the following items for selection.
2. In the Media Detailed Settings dialog box, select a setting from the Far End Margin list
under Roll Paper Margin for Safety.
Far End Margin presents the following items for selection.
Between
Pages
Setting Details
Printer Default This item resets the value to the printer default settings.
None Cancels the ink drying time.
30 sec., 1 min.,
3 min., 5 min.,
10 min., 30
min., 60 min.
After the print job finishes, the printer waits for this time to elapse
and then ejects the printed sheet. If the ink on the printed media is
difficult to dry, increase the time with a higher setting.
Between
Scans
Setting Details
Printer Default This item resets the value to the printer default settings.
None Cancels the ink drying time.
1 sec., 3 sec.,
5 sec., 7 sec.,
9 sec.
Increase this setting if you see stains on the printed sheets or
blurred colors in printouts done with borderless printing.
Near End Margin
Setting Details
Printer Default This item resets the value to the printer default settings.
5 mm Select this setting when you are not experiencing problems. Prints
a standard size margin.
20 mm Select this setting if the media has a strong tendency to curl,
causing the printhead to scratch its surface. This setting sets the
margin about 15 mm (in the feed direction) longer than the
standard margin for the media size.
Far End Margin Setting Details
Printer Default This item resets the value to the printer default settings.
5 mm Select this setting when you are not experiencing problems. Prints
a standard size margin.
10 mm Select this item when the cutter is fouling the printout as a result of
dry ink that adheres to the cutter after it has cut sheets where
printing was done as far as the trailing edge. This setting sets the
margin about 5 mm (in the feed direction) longer than the standard
margin for the media size.
To Next Page
Loading...
Need help?
General