73
Routine Maintenance
Loading Tab Paper
This section describes how to load tab paper.
You can load tab paper to the following paper source:
• Paper Drawer 3 and 4 of the main unit
• Multi-drawer Paper Deck-A1
• Document Insertion Unit-H1
• Document Insertion/Folding Unit-G1 / Document Insertion Unit-J1
Only LTR tab paper can be used.
When you load tab paper into the paper drawer or Multi-drawer Paper Deck-A1, make sure to register the paper type. (See
e-Manual > Settings/Registration.)
How to Load Tab Paper
There are two kinds of tab paper: right order tab paper and reverse order tab paper.
4
3
2
1
1
2
3
4
Right Order Tab Paper Reverse Order Tab Paper
You cannot make copies or prints on tab paper that is loaded in the Document Insertion Unit-H1/Document Insertion/Folding
Unit-G1/Document Insertion Unit-J1.
• You can use tab paper set in Document Insertion Unit-H1/Document Insertion/Folding Unit-G1/Document Insertion Unit-J1
for Add Cover, Insert Sheets or Job Separator.
• If you want to insert printed tab paper as a chapter pages, insert a blank paper where the tab paper will be inserted.
To Next Page
Loading...
Need help?
General
