Canon iR6000 - Enlarging and Reducing; Reducing (Preset); Enlarging (Preset); Reducing;Enlarging in 1% Increments

4
ENLARGING/REDUCING
REDUCING (Preset)
To reduce A3→ A4
1. Place the A3 original in the document feeder, or place original on platen glass.
2. Press the Copy Ratio button.
3. Press A3→A4 button (left hand side).
4. Enter the desired number copies, and press the Start button.
ENLARGING (Preset)
To enlarge A4→A3
1. Place A4 original in the landscape direction (horizontal) in the feeder.
2. Adjust the slide guides to fit the paper, or place the original on the glass in the A4R direction.
3. Press the Copy Ratio button.
4. Select A4→A3 button (on the right hand side)
5. Enter the desired number copies and press the Start button.
REDUCING/ENLARGING IN 1% INCREMENTS
1. Place originals in feeder face up, or on the platen glass. Face down.
2. Press the Copy Ratio button.
3. Using the numeric pad, enter the ratio (between 25%-800%).
4. Press the done button.
5. Enter the desired number copies, and press the Start button.
AUTO ZOOM
Use to copy from odd size originals to standard size paper. The machine automatically calculates the copy
ratio based on the size of paper and the selected copy paper size.
1. Place originals in the document feeder only.
2. Press the Copy Ratio button.
3. Select Auto Zoom button.
4. Select the paper size to copy on.
5. Enter the desired number copies, press the Start button.
FIT IMAGE MODE
Use to copy from edge to edge originals. The image is reduced slightly so that the whole of image is copied
without cropping the edges.
1. Place originals.
2. Press the Copy Ratio button.
3. Select Entire Image button.
4. Enter the desired number copies, press the Start button.