54
Display
1920 x 1200,60Hz
1280 x 800,60Hz
Display
System
1024 x 768,60Hz
----
----
----
Signal Format
Signal Format selection
If a PC is selected as the input signal source, your projector will detect and adapt to its signal for-
mat automatically. Correct image can be displayed without any setup operation.
Your projector will display one of the following:
Auto
-----
The Auto PC Adjusting function
will make necessary adjustment
to your projector to project valid
images. If images are displayed
incorrectly, adjust it manually.
No PC signals detected. Check
the connection between PC and
your projector.
signal format menu
The selected input signal displays in
the signal format menu.
Note:
Your projector may save data generat-
ed by the Auto PC Adjusting function.
Select the signal format manually.
1 Press the MENU button on remote controller
and the OSD displays. Press button to point
to the Input icon, press button or OK button
and the Input menu displays.
2 Press button to select Signal Format, then
press OK button.
Note:
The signal format menu will be dis-
abled once HDMI-1,HDMI-2, Memory
Viewer, LAN,USB Display has been
selected.
To Next Page
Loading...
Need help?
General
