Entering Sleep Mode
0UWX-01E
The sleep mode function reduces the amount of power consumed by the machine by disabling power ow to the
operation panel. If no operations will be performed on the machine for a while, such as during a lunch break, you can
save power simply by pressing on the operation panel. You can also use the Auto Sleep Time setting to
automatically put the machine into sleep mode if it remains idle for a specied length of time.
When in sleep mode
● When the machine enters sleep mode, lights up yellow green.
Situations in which the machine does not enter sleep mode
● When the machine is in operation
● When the Processing/Data indicator is lit up or blinking
● When the machine is performing an operation such as adjustment or cleaning
● When a paper jam occurs
● When the receiver of the external telephone or the optional handset is off the hook
● When the menu screen is displayed
● When a job is waiting to be scanned to a USB memory device or to a computer
● When an error message is displayed on the screen (There are some exceptions. The machine sometimes
enters sleep mode when error messages are displayed.)
● When the machine is communicating with an LDAP server, etc.
● When the SSID/network key screen for Direct Connection is displayed
● When settings data is being imported/exported
When You Want to Set the Auto Sleep Timer
The factory default settings for the amount of time that elapses before the machine enters auto sleep mode is 3
minutes (the user setting range is 3 to 60 minutes). We recommend using the factory default settings to save
the most power. If you want to change the amount of time that elapses before the machine enters auto sleep
mode, follow the procedure below.
<Menu>
<Timer Settings>
<Auto Sleep Time>
Set the amount of time that elapses before the
machine automatically enters sleep mode
<Apply>
Basic Operations
101
To Next Page
Loading...
Need help?
General
