dvanced Guide
>
Printing on DVD/CDs
> Printing on the Label Side of DVD/CDs > Printing from Photo Data
Printing from Photo Data
Print an image on a memory card onto a printable DVD/CD.
Important
You cannot print on 8 cm DVD/CDs.
Note
If printing is misaligned, adjust the printing position. For information on how to adjust it, see
djusting the Print Area
.
1.
Make sure that the machine is turned on.
2.
Select
DVD/CD label print on the HOME screen, then press the
OK
button.
3.
Select
From photo data, then press the
OK
button.
4.
Confirm the message, then insert the memory card into the Card Slot.
The print area setting screen is displayed.
5.
Use the or button to select Outer circle or Inner circle and use the or
button to change the print area.
6.
Press the
OK
button.
Note
Measure the outer and inner diameters of the printing surface of the printable DVD/CD and
make sure you set a value smaller than the measured value for the outer diameter, and a value
larger than the measured value for the inner diameter.
For information on printable discs, contact their manufacturers.
7.
Use the or
button to select Recommended DVD/CD or Other DVD/CD, then
press the
OK
button.
Note
If your medium is the recommended DVD or CD, specify Recommended DVD/CD for the
suitable density printing. If not, specify Other DVD/CD.
8.
Use the or button to select the photo to print, then press the
OK
button.
9.
Confirm the print image on the DVD/CD, then press the
OK
button.
Note
Other options
Printing a Specified Area (Trimming)
Searching for Photos with the Shooting Date (Search)
10.
Check the print settings, then press the
OK
button.
The message for preparation is displayed.
Note
To change print settings, press the
Back
button repeatedly until the screen for the setting item
Page 596 of 805 pagesPrinting from Photo Data
To Next Page
Loading...
