Canon Multi Function Professional Puncher-A1 - Page 8

■ In the Case of Document Insertion
Unit
1. Install the 2 Latch Plates to the Document Insertion
Unit.
• 4 Screws (Binding; M4 x10)
4x
2. Install the Positioning Pin.
• 2 Screws (Binding; M4 x10)
2x
■ Connection with the Upstream
Equipment
NOTE:
Although the host machine is used in the following
illustrations, the procedure is the same.
1. Open the Front Cover of this equipment.
2. Loosen the screw, and turn the connection lever to
raise the hook.
1x
Loosen
1. Installation
8
閲 FT2-0208-030_20160510.pdf 8 2016/05/10 14:39:52