Canon MV690 - Recording Movies on Tape; Recording Preparation and Operation

22
Recording Movies on a Tape
Before You Begin Recording
Make a test recording first to check if the camcorder operates correctly. Before you
make important recordings, clean the video heads ( 135).
Recording
1. Remove the lens cap.
2. Set the camcorder to CAMERA
mode.
• Set the POWER switch
to CAMERA and the TAPE/CARD switch
to b.
• Set the POWER
switch to CAMERA.
3. Push the OPEN button at the LCD
panel and open the LCD panel.
4. Press the start/stop button to begin
recording.
Press the start/stop button again to pause
recording.
When You Have Finished Recording
1. Turn the POWER switch to OFF.
2. Close the LCD panel and return the viewfinder into its initial position.
3. Replace the lens cap.
4. Unload the cassette.
5. Disconnect the power source.
r
e
(VCR)
POWER
CAMERA
CAMERA
PLAY
OFF
q
w
(VCR)
P
O
W
E
R
POWER
CAM
ERA
CAMERA
PLAY
PLAY
O
FF
OFF