Restore a certificate and a private key
When to do
You can restore the certificate and the private key at any moment, in case of need.
Restore the certificate and private key
Procedure
1.
In a web browser, open Océ Express WebTools (http(s):\\[IP address or hostname])
2.
On the Configuration - Remote security page, select [Restore certificate and private key]
3.
Browse to the back up file
4.
Enter the password of the back up file
5.
Click 'Restore'
6.
A dialog box opens: [This action will overwrite the current certificate. Continue?]
Click 'OK'
7.
When the key and the certificate are successfully restored, restart the controller.
Reset the current certificate
Purpose
This procedure creates a new Océ self-signed certificate.
When to do
You can reset the certificate after a certificate request or at any moment when you want to restore
a self-signed certificate.
NOTE
Prefer the restoration of the original self-signed certificate (that requests a preliminary back up of
the original self-signed certificate. See
Back up a certificate and a private key
on page 140):
Each 'Reset certificate' action generates a new self-signed certificate (with a new private and
public key). So each time you reset the certificate, you must import the new certificate into the
web browser.
Reset the certificate
Procedure
1.
In a web browser, open Océ Express WebTools (http(s):\\[IP address or hostname])
2.
On the Configuration - Remote security page, select [Reset certificate]
3.
Click the 'Reset' button
4.
When the reset is successful ([Certificate successfully reset]), restart the controller
Result
A new self-signed certificate has been generated on the controller.
Configure your web browser to use it (see
Use the Océ self-signed certificate with Internet
Explorer
on page 135)
Restore a certificate and a private key
144
Chapter 3 - Security on Océ PlotWave 500 and PlotWave 340/360
To Next Page
Loading...
