95
In D mode, you can choose 3 levels of flash output.
Set the mode dial to D .
Choose Flash Output.
● After pressing the m button, press the
op buttons to choose ~.
Make the setting.
● Press the qr buttons or turn the  dial to
choose the amount of Flash Output, then
press the m button.
X Once set, ~ will appear on the screen.
When the camera detects the possibility that people have their eyes shut,
appears.
Choose [Blink Detection].
● Press the n button, then choose
[Blink Detection] in the 4 tab. Press the
qr buttons to choose [On].
Shoot.
X When a person with shut eyes is detected,
a frame and appear.
Adjusting the Flash Output
• You can also set the flash output. Press the n button and choose
[Flash Settings] (p. 93) from the 4 tab. Then choose [Flash Output] and
press the qr buttons to choose a setting.
• In M and B modes, you can set the flash output if you press the
n button and choose the 4 tab, then choose [Flash Settings] and
set the [Flash Mode] option to [Manual].
• With the flash raised, if you press the r button and immediately press the
n button, the setting screen will appear.
Checking for Shut Eyes
• In or $, when the number of shots is set to two or more, this function
is only available for the last image shot.
• Not available in W, , or .
To Next Page
Loading...
