FCC Notice
(Digital Camera, Model PC1562 systems)
This device complies with Part 15
of
the FCC Rules. Operation
is
subject to the following
two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for Class B
digital devices, pursuant to Part 15
of
the FCC rules. These limits are designed to
provide reasonable protection against harmful interference
in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used
in
accordance with the instructions, may cause harmful interference
to radio communications. However, there
is
no guarantee that interference will not occur
in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can
be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more
of
the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet
on
a circuit different from that to which the
receiver
is
connected.
Consult the dealer or
an
experienced radiolTV technician for help.
The cable with the ferrite core provided with the digital camera must be used with this
equipment
in
order to comply with Class B limits
in
Subpart B of Part 15
of
the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified
in
the manual. If such changes or modifications should be made, you could
be
required
to stop operation
of
the equipment.
Canon U.S.A., Inc.
One Canon Plaza, Lake Success, NY 11042, U.S.A.
Tel No. (516) 328-5600
Canadian Radio Interference Regulations
This Class B digital apparatus complies with Canadian ICES-003.
35
To Next Page
Loading...
