119
Before Use
Basic Guide
Advanced Guide
Index
Camera Basics
Auto Mode /
Hybrid Auto Mode
Other Shooting Modes
P Mode
Tv, Av, and M Mode
Playback Mode
Wireless Features
Setting Menu
Accessories
Appendix
Using Another Access Point
When connecting the camera to a smartphone through the Wi-Fi menu,
you can also use an existing access point.
1
Prepare for the connection.
● Access the [Waiting to connect] screen
by following steps 1 – 4 in “Adding a
Smartphone Using the Wi-Fi Menu”
(
=
117).
2
Connect the smartphone to the
access point.
3
Choose [Switch Network].
● Press the [ ][ ] buttons or turn the [ ]
dial to choose [Switch Network], and then
press the [ ] button.
● A list of detected access points will be
displayed.
4
Connect to an access point.
● For WPS-compatible access points,
connect to the access point as described
in steps 5 – 8 in “Using WPS-Compatible
Access Points” (
=
122).
● For non-WPS access points, follow steps
2 – 4 in “Connecting to Listed Access
Points” (
=
124) to connect to the
access point.
● All images in the camera can be viewed from the connected
smartphone when you choose [Yes] in step 8. To keep camera
images private, so that they cannot be viewed from the
smartphone, choose [No] in step 8.
● Once you have registered a smartphone, you can change privacy
settings for it on the camera (
=
139).
● Connections require that a memory card be in the camera.
● Once you have connected to devices via the Wi-Fi menu, recent
destinations will be listed rst when you access the Wi-Fi menu.
You can easily connect again by pressing the [
][ ] buttons to
choose the device and then pressing the [
] button. To add a
new device, display the device selection screen by pressing the
[
][ ] buttons, and then congure the setting.
● If you prefer not to display recent target devices, choose MENU
(
=
29) > [ ] tab > [Wireless settings] > [Wi-Fi Settings] >
[Target History] > [Off].
● To connect without entering a password in step 5, choose MENU
(
=
29) > [ ] tab > [Wireless settings] > [Wi-Fi Settings] >
[Password] > [Off]. [Password] is no longer displayed on the SSID
screen (in step 4).
● You can also send multiple images at once and change the image
size before sending (
=
132).
● You can send the current image by choosing [Send this image] on
the screen in step 9.
To Next Page
Loading...
Need help?
General
