Canon Selphy CP910 - Printing from a Computer; Confirming Access Point Compatibility

36
Cover
Contents
Part Names
Basic Operations
Print Settings
Printing via USB
Cable
Troubleshooting
Appendix
Printing via Wi-Fi
Printing from a Computer
Confirming Access Point Compatibility
• Before you can print via Wi-Fi from a computer, the computer with the
images to send must be connected to an access point.
• Use an access point that supports the following Wi-Fi standards. To
check the standards your access point supports, refer to the access point
user manual.
Standards IEEE 802.11b/g
Supported
Channels
1 – 11
Transmission
Methods
DSSS (IEEE 802.11b) and OFDM (IEEE 802.11g)
Security
No security, 64- and 128-bit WEP (open system authentication),
WPA-PSK (TKIP), WPA-PSK (AES), WPA2-PSK (TKIP), and
WPA2-PSK (AES)
• Confirm that the access point supports WPS (Wi-Fi Protected Setup).
WPS-Compatible Access
Points
Connect as described in “WPS-Compatible Access
Points” (=
37)*.
Non-WPS Access Points
Or WPS Support Unknown
Check the following information and connect as
described in “Non-WPS Access Points” (=
39).
- Network name (SSID/ESSID)
- Network authentication / data encryption (encryption
method or mode)
- Password (network key)
* WPS connections are not possible for access points set up for WEP security. Connect
as described in “Non-WPS Access Points” (=
39).
• If your network is managed by a system administrator, ask the
administrator for network setting details.