162
For dome case attachment, see the “Installation
Guide” included with the camera.
Important
If the reset switch is pushed, network-related settings will also
be restored to factory default settings including the camera's IP
address, subnet mask, default gateway address, etc.
Accordingly, you can no longer operate the camera from the
PC you were using to connect to the camera before. When
initializing the camera, use the “VB Initial Setting Tool” installed
in your PC to set an IP address appropriate for the environment
in which the camera is used (See “Performing Initial Settings for
the Camera” (p. 28)).
Reset Switch
VB-H41
VB-H610VE
Reset Switch
VB-H610D
Reset Switch
4
For VB-H610VE/VB-H610D, attach the dome case.
Reset Switch
VB-H710F
To Next Page
Loading...
