Preparing the Power Supply
18
To remove the battery pack
1 Slide the BATTERY RELEASE switch in the direction of the arrow
and hold it pressed down.
2 Slide the battery pack down and then pull it out.
Checking the Remaining Battery Charge
With the camcorder turned off, press the BATT. INFO button to
display for about 5 seconds a screen showing the approximate
battery charge level. Note that if the battery charge is too low,
the battery information screen may not appear.
Using a Power Outlet
You can power the camcorder directly from a power outlet
using the USB power adapter.
1 Plug the USB power adapter into a power outlet.
2 Attach the cable clamp to the grip belt and use it
to secure the cable.
• The ferrite core should be placed between the USB
plug and the cable clamp.
3 Connect the USB plug to the DC IN terminal.
• [DC IN] will be displayed when you turn on the
camcorder.
• Do not connect to the USB power adapter any product that is not expressly recommended for use with this
camcorder.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
