SmartLock
®
Controller Page 13 of 26
Installation Manual Nov 2018 • Rev. 3.2
Reader Wiring
WIEGAND READER
IMPORTANT: Before applying power to the controller, verify that the
reader voltage jumper is set correctly for the reader being connected.
Connecting a 5 V reader to a 12 V power supply will damage the reader.
NOTE: The SmartLock
®
controller supports Cansec’s 37-bit format as well as
standard 26-bit format.
CABLE: 22 AWG, 6 CONDUCTORS,
NON-TWISTED PAIR, OVERALL
SHIELDED, MAX. DISTANCE IS
500ft (152 m)
To Next Page
Loading...