Canton Smart Amp 5.1 - LED Indications; Display Indications

3
83
English
LED indications
The LED indicates the following conditions:
• LED off (not illuminated) Amplifier disconnected from the mains
• LED shining red Amplifier in standby mode
• LED flashing green quickly Amplifier is booting
• LED shining green Amplifier is active (network connected)
-------------------------------------------------------------------------------------------------------------
• LED flashing green slowly Network disconnected
• LED flashing green Network setup mode
• LED flashing green/red Amplifier is executing a FW update
• LED flashing green two times Ethernet setup mode (LAN connected)
Display indications
On-Screen Display (OSD)
All settings and configurations of the Amp 5.1 can comfortably be done using the On-Screen display with your TV-Screen. To do so the Amp
must be connected with your TV using a HDMI
®
-cable. The menu is comprehensibly structured. Pressing the menu button (M) on the remote
guides you to the main menu.
Note:
To change the language of the OSD (German or English), navigate to the main menu by pressing the menu button "M".
Select the menu Systemeinstellungen [SYS] by using the arrow buttons " " or " " and enter by pressing the "OK" button.
Use the arrow buttons " " or " " to select the menu item Sprache [LAN] and confirm by pressing the "OK" button.
Use the "+" or "-" button to select the desired language as German [DEU] or English [ENG] and confirm your selection with the "OK"
button.
Exit the menu by pressing and hold the menu button "M".