Canton Smart Amp 5.1 - Sleep Timer (SLP) Configuration

98
English
To set the device heights please do as follows:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK button.
3
Use the " " or " " button to select the menu item Device Heights [DHE] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to select the desired pair of speakers (front or rear) and confirm your selection with the "OK" button.
5
Use the "+" resp. the "–" key to set the height and confirm your selection with the "OK" button. Repeat this steps in case for the other
pair of speakers.
6
Confirm and exit the menu item by pressing the "M" button.
2. System Setup [SYS]
The second item in the main menu is the System Setup. It contains the following menu items:
•Sleep Timer [SLP]
•IR Menu [IRM]
–IR Learn [IRL]
–Direct Input Learn [DIL]
–IR Clear [RES]
•HDMI CEC [CEC]
•Standby Mode [STB]
•Input Config [INP]
•Analog Gain [OFS]
•Input Select [SEL]
•Lipsync [LIP]
•Max Volume [VOL]
•Playmode [PLM]
•3D Audio [3D]
•Display Setup [UI]
–Language [LAN]
–LED Flashing [LED]
•Factory Reset [RES]