110
English
5
To cancel the reset procedure, press the input select key " ". The display shows [RES] again. Press this key additional two times to exit
the menu.
6
To execute the reset, keep "Reset All" [YES] and confirm with the Play/Pause button " ". The display then shows [YES] to confirm the
reset procedure, the OSD shows "Please Wait".
7
After some seconds the Amp 5.1 returns to the Network Connection [NWC] menu to the menu item Network Reset [NWR] and the dis-
play shows [NWR] again. To exit the menu press the input select key "
" twice.
To perform the reset using the remote control, proceeed as follows:
1
Power up your Amp 5.1 using the Power " " key.
2
To enter the menu, press the "M" button until the display shows [SPS] and the Main Menu is entered.
3
Use the " " or " " button to navigate to the menu Network Setup [NWS] and confirm with the "OK" button.
4
Select the function Network Reset [NWR] and confirm with the "OK" button. The display shows [YES], the OSD indicates "Reset All".
5
To cancel the reset procedure, press the "M" button. The display shows [RES] again. Press this key additional two times to exit the menu.
6
To execute the reset, keep "Reset All" [YES] and confirm with the "OK" button. The display then shows [YES] to confirm the reset proce-
dure, the OSD shows "Please Wait".
7
After some seconds the Amp 5.1 returns to the Network Connection [NWC] menu to the menu item Network Reset [NWR] and the dis-
play shows [NWR] again. To exit the menu press the "M" button.
To Next Page
Loading...
