Canton Smart Amp 5.1 - Atmos Speaker and Subwoofer Setup

3
117
English
• (7) Top Rear left and right [TR]: They reproduce the Dolby Atmos
®
signals as
well. To get an even more detailed spatial impression (3D Sound) you can use
two additional upfiring speakers or ceiling speakers . The upfiring speakers (Dolby
Atmos
®
Enabled speaker) are placed on top of the rear left and right speakers [RER]
or the surround speakers [SUR]. When using ceiling speakers the position of the
front speakers [TF] should be left and right in an angle between 30° and 55°, the
rear speakers [TR] in an angle between 125° and 150° above the listening position
(please refer to figure 1.1).
•
(8) Subwoofer [SUB]: The subwoofer reproduces the LFE channel (Low Frequency
Effect). Additionally the subwoofer reproduces all frequencies that can not be repro-
duced by "small" speakers und are below the set crossover frequency (e.g. 100Hz)
(please refer to the menu item Crossover [XOV]).
Figure 1: Home cinema setup
Figure 1.1: Setup Atmos speaker