What to do if the lights and fan on my Caple ATA900 Ventilation Hood do not work?
If your Caple Ventilation Hood's lights and fan aren't working, it could be due to a blown fuse. In this case, replace the fuse. Another possible cause is a loose power cord. Ensure it is properly plugged into the power supply.
Why is my Caple Ventilation Hood vibrating so much?
If your Caple Ventilation Hood is vibrating excessively, it might be due to a damaged fan blade or a fan motor that isn't tightly fixed. In either case, switch off the unit and contact Caple Service for qualified repair. Alternatively, the unit may not be correctly hung on the bracket. In this instance, take down the unit and check the bracket's location.
How to improve the extraction performance of my Caple ATA900 Ventilation Hood?
If the extraction performance of your Caple Ventilation Hood isn't up to par, the filter likely needs cleaning. Clean the grease filter as instructed in the ‘Care and maintenance’ section. If your unit is in recirculation mode, consider replacing the charcoal filter.
What to do if the lights are on but the fan doesn't work on my Caple ATA900 Ventilation Hood?
If the lights on your Caple Ventilation Hood are on, but the fan isn't working, it could be that the fan blade is jammed or the motor is damaged. In the case of a jammed fan blade, switch off the unit and contact Caple Service. This should only be repaired by qualified service personnel.
General| Model | ATA900 |
|---|---|
| Brand | Caple |
| Width | 90 cm |
| Number of Speeds | 3 |
| Grease Filter Type | Aluminium |
| Lighting | LED |
| Number of Motors | 1 |
| Material | Stainless Steel |
| Installation | Wall-mounted |
| Power Supply | 220-240V |
To Next Page
