Installation
Caution: 2 people are required to unpack
and handle the product, it is recommended that
gloves are worn.
Carefully remove all packaging materials
including the foam base, dispose of correctly.
1. Ensure that the surface of the wall is flat, fre
e
of dust and dirt.
2. Carefully measure the wall and mark out the
correct position for the sp
lashback.
3. Glue the
support bracket of the splashback.
4. Drill the holes on the wall according to the
diagrams on right.
WA
RNING! Before drilling holes check the wall
is clear of any cables, pipes etc.
5. Use the screws (4x30m
m) and wall plugs
provided to fix the spla
shback (refer to
the
previous pag
e
to ensure suitable).
6. Tighten the
screws and press th
e splashback
to the wall.
7. Any gap b
etween the
worktop and the wall
must be sealed to exclude moisture.
4
To Next Page
Loading...
