Instruction manual DD810BK
18
Please keep this instruction manual for future reference
PROTECTION AGAINST OVERHEATING (INDUCTION):
If the hob is used at full power for a longer period, it will not be possible to cool down the
electronics system as required at a high room temperature.
In order to ensure that no excessive temperatures occur in the electronics system, the power of the
cooking zones may be reduced automatically.
Should E2 be displayed frequently during normal use of the hob and at normal room temperature,
it is likely that cooling is not sufficient.
This may occur if kitchen units have no openings. The installation may have to be checked.
SUITABLE COOKWARE UNSUITABLE COOKWARE
Enamelled steel pans with a thick base.
Pans made of copper, stainless steel,
aluminium, oven-proof glass, wood,
ceramic and terracotta.
Cast iron pans with an enamelled base.
Pans made of multi-layer stainless steel, stainless ferrite steel
and aluminium with special base.
OTHER FUNCTIONS:
If two or more sensor keys are pressed at the same time (e.g. when a pan is mistakenly put onto a
sensor key) no function will be activated.
The ‘symbol Er03’ will blink and a time-limited continuous signal will sound. After a few seconds
the appliance will switch off. Please remove the item located in front of the sensor keys. To delete
the ‘symbol Er03’ press the same key or switch the hob off and on.
COOKWARE FOR INDUCTION HOBS:
Cookware for induction cooking zones must be made of metal and have magnetic properties. The
base must be sufficiently large.
Only use pans with a base suitable for induction.
To Next Page
Loading...
