Caple DD810BK - Page 45

Instruction manual DD810BK
45
Please keep this instruction manual for future reference
FLUSH INSTALLATION:
Glue the sealing tape onto the corner of
the supporting edge of the worktop so
that no silicone adhesive can be pressed
under the hob.
Place the hob into the worktop cut-out
without any adhesive and align it. Use
shims if necessary.
Fill the gap between the hob and the
worktop with heat-resistant
silicone adhesive.
IMPORTANT:
Silicone adhesive must not get under the support surface. If this occurs it will not be possible to
remove the hob again at a later stage. No liability will be assumed in the case of failure to observe
these instructions.
750+1
min.50
500+1
524+1
804+1
1
2
2
3
3
R7 3
min.50
1
212
4, 5-0, 5
750+1
min.50
500+1
524+1
804+1
1
2
2
3
3
R7 3
min.50
1
212
4, 5-0, 5
4,5 -0,5