Caple RI7306 - Cleaning and Maintenance

32 33Instruction manual Ri7306 Instruction manual Ri7306Please keep this instruction manual for future reference Please keep this instruction manual for future reference
CLEANING AND MAINTENANCE
Disconnect the unit from the power supply before cleaning.
Do not wash your appliance by pouring water on it.
Do not use abrasive products, detergents or soaps for cleaning the appliance. After washing,
rinse with clean water and dry carefully. When you have finished cleaning, reconnect the plug
to the mains supply with dry hands.
› Make sure that no water enters the lamp housing and other electrical components.
› The appliance should be cleaned regularly using a solution of bicarbonate of soda and
lukewarm water.
› Clean the accessories separately by hand with soap and water. Do not wash accessories in
a dish washer.
› Clean the condenser with a brush at least twice a year. This will help you to save on energy
costs and increase productivity.
NOTE:
The power supply must be disconnected during cleaning.
DEFROSTING THE REFRIGERATOR COMPARTMENT
› Defrosting occurs automatically in the
refrigerator compartment during operation.
The water is collected by the evaporation
tray and evaporates automatically.
› The evaporation tray and the water drain
hole should be cleaned periodically with
the defrost drain plug to prevent the
water from collecting at the bottom of the
refrigerator instead of flowing out.
› You can also clean the drain hole by
pouring half a glass of water down it.
EN - 22
• Do the food packages prevent closing
of the door?
• Are the door compartments, shelves
and drawers placed properly?
• Are door joints broken or torn?
• Is your fridge freezer on a level
surface?
Recommendations
• To stop the appliance completely,
unplug from main socket (for cleaning
and when the door is left open)
Replacing LED Lighting
To replace any of the LEDs, please
contact Caple service to arrange. This
should only be performed by a qualified
electrician.
Note: The numbers and location of the
LED strips may change according to the
model.
LED strip
6.1. Defrosting the refrigerator compartment
• Your refrigerator performs automatic
defrosting. The water formed as a
result of defrosting passes through
the water collection spout, ows into
the vaporisation container behind your
refrigerator and evaporates there.
• Make sure you have disconnected
the plug of your refrigerator before
cleaning the vaporisation container.
• Remove the vaporisation container
from its position by removing the
screws as indicated. Clean it with
soapy water at specic time intervals.
This will prevent odours from forming.