38 39Instruction manual Ri7306 Instruction manual Ri7306Please keep this instruction manual for future reference Please keep this instruction manual for future reference
ENERGY SAVING TIPS
1. Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near
a heat source (such as a radiator or oven) otherwise an insulating plate should be used.
2. Allow warm food and drinks to cool before placing them inside the appliance.
3. Place thawing food in the refrigerator compartment. The low temperature of the frozen
food will help cool the refrigerator compartment while the food is thawing. This will save
energy. Frozen food left to thaw outside of the appliance will result in a waste of energy.
4. Drinks or other liquids should be covered when inside the appliance. If left uncovered,
the humidity inside the appliance will increase, therefore the appliance uses more energy.
Keeping drinks and other liquids covered helps preserve their smell and taste.
5. Avoid keeping the doors open for long periods and opening the doors too frequently as
warm air will enter the appliance and cause the compressor to switch on
unnecessarily often.
6. Keep the covers of the different temperature compartments ( such as the crisper and
chiller) closed.
7. The door gasket must be clean and pliable. Replace gaskets if worn.
IS ALL THE FOOD PACKED PROPERLY?
› Are the containers dried before placing them in the fridge?
› Are the fridge freezer’s doors opened frequently? Humidity of the room gets in the fridge
when the door is opened. Humidity build up will be faster when you open the door more
frequently, especially if the humidity of the room is high.
IF THE DOORS ARE NOT OPENED AND CLOSED PROPERLY
› Do the food packages prevent closing of the door?
› Are the door compartments, shelves and drawers placed properly?
› Are door joints broken or torn?
› Is your fridge freezer on a level surface?
RECOMMENDATIONS
› To stop the appliance completely, unplug from main socket (for cleaning and when the
door is left open).
› If the appliance is switched off or unplugged, wait at least 5 minutes before plugging the
appliance in or restarting it in order to prevent damage to the compressor.
If the problem persists or more help is required, please contact our Caple service team on
0117 938 7420 or via email service@caple.co.uk
To Next Page
Loading...
