Caple RI7306 - Warnings

6 7Instruction manual Ri7306 Instruction manual Ri7306Please keep this instruction manual for future reference Please keep this instruction manual for future reference
- Consult a qualified electrician or service person if the
Grounding instructions are not completely understood,
or if you have doubts on whether the appliance is
properly grounded.
- The incorrect grounding may cause breakdown and
electric shock.
- We do not accept responsibility for any damages that
occur due to ungrounded usage.
- If the socket does not match the refrigerator plug, it
must be replaced by the manufacturer, a service agent
or similarly qualified persons in order to avoid
a hazard.
- A specially grounded plug has been connected to the
power cable of your refrigerator. This plug should be
used with a specially grounded socket of 13 amperes.
If there is no such socket in your house, please have
one installed by an authorised electrician.
INSTALLATION WARNINGS:
- Prior to installation, ensure that the local distribution
conditions (electricity voltage and frequency) and the
requirements of the appliance are compatible.
- During installation the appliance must be completely
disconnected from the mains electricity supply.
- Do not operate the appliance before it is fully installed.
- The appliance must be installed by an
authorised technician.
- In order to avoid any hazards resulting from the
instability of the appliance, it must be fixed in
accordance with the following instructions.
- This appliance is not intended for use at altitudes
exceeding 2000m.
- Your appliance must be at least 50 cm away from
stoves, gas ovens and heater cores, and at least 5 cm
away from electrical ovens.
- If your fridge freezer is placed next to a deep freezer,
there must be at least 2cm between them to prevent
humidity forming on the outer surface.
- Clearance of at least 150 mm is required at the top of
your appliance. Do not place anything on top of
your appliance.
- Caple is not responsible for any damage that may
be caused by defective placement and installation by
unauthorised persons.
- When unpacking the appliance, make sure that it is not
damaged during transportation.
- Check the appliance for any damage.
- In the case of any defect; do not use the appliance and
contact your retailer or Caple Service immediately.
- Ensure that the supply cord is not wedged, trapped
or damaged during the installation. If the supply cord
is damaged, it must be replaced by a Caple service
technician or similarly qualified persons in order to
prevent a hazard.