17Instruction manual WDi3301Please keep this instruction manual for future reference
CONNECT INLET PIPE
WARNING:
› To prevent leakage or water damage, follow the
instructions in this chapter.
› Do not kink, crush, modify or sever water inlet hose. The
washer dryer should be installed in its final position such
that the inlet pipe is not trapped.
1. Connect the inlet pipe to the water supply tap. Only use
the pipe supplied with the appliance (do not reuse old
pipe-sets).
2. Connect the other end of the inlet pipe to the inlet valve
at the back of the washer dryer and fasten the pipe tightly
clockwise.
NOTE:
If there is any leakage with the hose, repeat these steps to connect the inlet hose.
CONNECT OUTLET HOSE
WARNING:
› Do not kink or trap the drain hose.
› Position drain hose properly, otherwise damage might result of water leakage.
› When installing drain hose, fix it properly.
› If drain hose is too long, do not force it into the washer dryer as it will cause
abnormal noises.
The drain hose should be inserted into suitable drain pipe of between 60cm and 100cm height
above the floor using the curved drain hose support.
The drain hose can be connected in three different ways:
1. Connect it to a drain pipe
2. Attach it to a sink
3. Connect it to the sink drain pipe
1. .
Only e
CONNECT OUTLET HOSE
60100
The drain hose can be connected in three different ways:
1.Connect it to a drain pipe
2.Attach it to a sink
3.Connect it to the sink drain pipe
er dryer
If there is any leakage with the hose,
repeat the steps to connect inlet hose.
2.other end of the inlet pipe to the
inlet valve at the back of the washing machine and
fasten the pipe tightly clockwise.
9
10
INSTALLATION
1.Check if the legs are closely attached to the cabinet. If not, please turn them to
their original positions tighten the nuts.
2.Loosen the lock nut turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a spanner, make sure the machine is steady.
Levelling the washer dryer
•The lock nuts on all four feet must be screwed tightly against the housing.
Connect Water Supply Hose
Connect the inlet pipe as indicated, There are two ways to connect the inlet pipe.
1.Connection between ordinary tap and inlet hose.
•To prevent leakage or water damage, follow the instructions in this chapter
Do not kink, crush, modify or sever .
!
•water inlet hose
•For the model equips hot valve,connect it to hot water tap with hot water supply
hose. Energy consumption will decrease automatically for some program.
2
3
4
1
Raise
Lower
Lock nut
foot
Warning!
！
Warning!
！！
Loosen clamp nut and
four bolts
Tighten clamp nutPress slide bushing,
insert inlet hose into
connecting base
slide bushing
2
3
41
Connection finished
clamp nut
Tap with threads and inlet hose
Special tap for washer dryer
2.Connection between screw tap and inlet hose.
slide bushing
1. .
Only e
CONNECT OUTLET HOSE
60100
The drain hose can be connected in three different ways:
1.Connect it to a drain pipe
2.Attach it to a sink
3.Connect it to the sink drain pipe
er dryer
If there is any leakage with the hose,
repeat the steps to connect inlet hose.
2.other end of the inlet pipe to the
inlet valve at the back of the washing machine and
fasten the pipe tightly clockwise.
To Next Page
Loading...
