completely. The red drawer light will
turn off.
Important: Make sure that the used
coffee container is placed onto the tray
before inserting the complete drawer
back into the machine. Otherwise, the
used coffee will fall into the drawer and
might overflow.
Note: Whenever the drawer is outside of
the machine, you can clean the inside
of the machine with a damp cloth.
11.2 Tray / Drawer Missing
Whenever the drawer and tray are out-
side of the machine or if they are not
properly inserted, the red drawer light
and the green READY light are
blinking. Insert the drawer with the tray
correctly into the machine.
11.3 Fill Water
When the red refill light illuminates,
the water level in the water tank is too
low. All coffee buttons are blocked and
you must add water before you can use
the machine again:
• Remove the water tank and fill with
fresh, cold water.
• Replace the water tank.
You can also lift the lid of the water tank
and use a separate container to pour
water into the water tank.
Note: The machine is designed to ask
for more water even if there is still some
water left in the water tank. This
ensures that the pump will never acci-
dentally run dry.
12. CHANGING THE FACTORY
SETTINGS
12.1 Adjusting On/Off and Auto-Off
The C1000 is set to shut off two hours
after last use. You can change this
setting to:
• 5-hour auto shut-off, or
• manual shut-off.
Important: Before you change the set-
ting, you must turn off the machine then:
• Press the 2-cup button for about 3
seconds. The lights are on
and the green hot-water light blinks
(this indicates 2 hour auto shut-off).
• Push the 2-cup button once more
and the lights are
illuminated (this indicates 5 hour auto
shut-off).
• Press the 2-cup button again and
only the red ON light is on and only
the green light blinks, indicating that
the machine requires manual shut-off.
Important: After you choose the setting
you prefer, you must push the main
ON/OFF button to confirm your
setting. The machine will turn off again
automatically.
• To change the setting, begin from the
start of this chapter (12.1) again.
12.2 Adjusting the Grinder
See chapter 8.3.
12.3 Adjusting the Water Hardness
Setting
The C1000 has five water hardness set-
tings levels 0, 1, 2, 3 and 4. The factory
setting is level 1. If you use the Claris
water cartridge, you can disconnect the
water hardness indicator (level 0). If you
have soft water, you can leave the
factory setting as is. If your water is
harder, change the setting according to
the table below. Ask your local water
company for the “Water Hardness in
Grains.”
Level Grains C1000 Lights
0 0-1
1 2-9
2 10-19
3 20-29
4 30+
To change the water hardness level,
proceed as follows:
• Turn the machine off.
• Press the 1-cup button for about 3
seconds.
• Press the 1-cup button repeatedly
until the required setting is indicated.
Important: After you choose the setting
15
To Next Page
Loading...
