N. Place an empty container underneath
the frother.
O. Turn the selector switch to the
steam/hot water position (see fig. 2b)
The red ON light is on and the green
hot-water light and the red decalci-
fying light are blinking. The machine
now pumps hot water through the
frother in short intervals.
P. When the pump stops, the hot-water
light is blinking and the three lights
are illuminated. Remove the
container from underneath the frother.
Remove and replace the drawer back
into the machine. The four green lights
start blinking and the
red ON light and red decalcifying
light are on.
Q. Turn the selector switch back to the
coffee position (see fig. 2a) and the pro-
gram will continue to process hot water
through the machine into the drawer.
The red ON light is on and the red
decalcifying light blink.
R. After a while, the green hot-water light
will blink and the three lights
illuminate.
S. Remove and empty the drawer
Caution: this is hot water! Replace the
drawer back into the machine.
The lights are blinking.
Place a container underneath the frother
and turn the selector switch to the
steam/hot water position (see fig. 2b)
T. Press the hot-water button . The
machine will pump some water through
the frother and stop automatically.
U. Place the container underneath the
coffee spout. Turn the selector switch
to the coffee position (see fig. 2a) and
push the hot-water button . The
machine will run one hot water rinse
cycle and stops.
The lights are now ON. You
are now ready to make coffee again.
How often do I have to decalcify?
The decalcification monitor measures
how much water is processed through
the C1000 (that is all the water for
coffee making, steaming, frothing,
rinsing etc., all hot water leads to
calcium deposits!). The harder the
water the faster the calcium deposits
will occur.
Do not select a water hardness level
which is lower than your actual water
hardness. In level “4” the decalcification
light will come ON after approx. 11 gal
lons of water (= 22 full water containers).
In level “3” approx. 44, in level “2”
approx. 80 and in level “1” approx.160
full water containers.
15. TROUBLE SHOOTING
15.1 Display messages
a) The red ON light is on and the
four green lights are
blinking?
• System is empty; fill the system (see
chapter 7.3 “First Time Preparation”)
• System is too hot (after frothing); reset
the machine; see chapter 10.1
“Resetting the Machine”.
• Selector Switch is in the steam/hot
water position; turn the selector switch
to the coffee position (see fig. 2a).
• The machine did not complete the
reset cycle. Repeat reset cycle (see
chapter 10.1).
• The machine did not complete the
hot-water-rinse cycle in time. Clean the
inner sieve (see chapter 13a) and run
the hot-water-rinse cycle again.
• When you turn the machine ON and
the selector switch is in the steam/hot
water position. Turn the selector switch
back to the coffee position.
b) The green hot-water light
illuminates?
• Machine requires a hot water rinse
cycle; push the button.
c) The green READY light blinks
and the red ON light and red refill
light are ON?
• Fill water into the water tank
• Check to make sure that the low
water flotation device is in place (see
fig. 4 call-out #4). If you cannot find this
19
To Next Page
Loading...
