What to do if my Caravaggi Chipper has a difficult start-up or loss of power?
If your Caravaggi Chipper experiences a difficult start-up or loss of power, examine the belt tension and condition, blocked pulleys, PTO, or gears. You should also check the state of the engine or motor, referring to the supplied instruction manual for guidance.
How to troubleshoot a Caravaggi Chipper that does not start?
If the Caravaggi Chipper does not start, verify the belt tension and condition, check for blocked pulleys, PTO, or gears. Ensure the cutters, blade, and counter-blade are in good condition and that there is no material obstructing the milling chamber. Also, check the condition of the engine or motor, referring to the supplied instruction manual.
Why does my Caravaggi Chipper lose revs and function irregularly?
If the Caravaggi Chipper loses revs and functions irregularly, check the belt tension and condition, look for blocked pulleys, PTO, or gears. Also, inspect the cutters, blade, counter-blade, and ensure the milling chamber is free of obstructions. Clear any blockages from the sieve. Check the engine or motor condition, consulting the supplied instruction manual. Finally, examine the material being chopped at the moment of breakdown.
What to do if the hopper of my Caravaggi Chipper rejects the material?
If the hopper of your Caravaggi Chipper rejects the material, inspect the cutters, blade, and counter-blade, and ensure the milling chamber is clear of obstructions. Check the condition of the engine or motor, referring to the supplied instruction manual. Also, verify the wear state of the hopper rubber protection.
Ensures operators are trained, responsible, and aware of safety for themselves and others.
Check blades, position machine safely, and follow shutdown procedures.
Guidelines for safe fuel storage, refueling in open air, and avoiding ignition sources.
Verify stable placement, clear zone, and check fuel/oil levels before operation.
Never insert hands or arms into the hopper; material diameter must not exceed 10 cm.
Use combustion engine machines only in open environments to avoid fume intoxication.
Always switch off the engine/motor and wear gloves before any maintenance.
Instructions for safely removing and fitting new chipping blades.
Steps for removing and replacing the counter-blade with a new one.
Procedure for inverting or replacing knives and breaker bars for balance.
Ensure balanced replacement of breaker bars by maintaining opposite positions.
To Next Page
General
