Page 5
Note: Where the operator has been specified with a 2-piece boom, please refer to the
assembly instructions for this item supplied with the boom.
a
Install grey motorshaft adapter onto motorshaft (if not already fitted).
Bolt rail with brackets and screws to motorhousing. Make sure the screws
are tightly fastened. N.B. Use 4 large Phillips HD selftap screws provided
Lens cover should face
rear of garage.
2 Fit the red slider that re-engages the emergency release and operator pull bar onto carriage.
a. Refer to fig.1 to fit the red slider that re-engages the emergency release knob onto carriage.
b. Refer to fig.2 to fit pull bar onto carriage. Note position of emergency release cord to
ensure correct cord position after installation.
OPERATOR ASSEMBLY
fig.1
fig.2
To Next Page
Loading...
