16
KEYPAD FUNCTIONS - MODEL 210, Cont.
0 THROUGH 9 KEYS
These keys are used to enter numeric data during the setup and calibration as well as during
normal operation of the instrument.
NOTE:
The 1 and 0 keys have dual functions. They are used
to enter numeric data during setup and calibration as well as during normal operations and are
also used to answer yes (1 = YES) or no (0 = NO) to various prompts.
ENTER KEY
The
ENTER
key serves two purposes. First, when reviewing setup parameters, pressing the
ENTER
key will display the current setting of the parameter. Second, the
ENTER
key is used to
signal completion of the entry of data and causes the indicator to process the data entered.
ASTERISK KEY
This key is used for several functions. During Setup, when a setup parameter (not a parameter
value) is displayed, pressing this key will "backup" to the previous prompt. In normal operation,
this key is used in conjunction with the other keys on the keypad to access additional indicator
features. These features and their associated key combinations are as follows:
ASTERISK, ZERO/REVIEW KEY
This combination will enter the Review mode of Setup and Calibration. Refer to Setup
Review section of this manual for details.
ASTERISK, NET/GROSS KEY
This combination will display the Net accumulator.
ASTERISK, NET/GROSS KEY, PRINT KEY
This combination will print the Net accumulator.
ASTERISK, NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Net accumulator.
ASTERISK, NET/GROSS KEY, NET/GROSS KEY
This combination will display the Gross accumulator.
ASTERISK, NET/GROSS KEY, NET/GROSS KEY, PRINT KEY
This combination will print the Gross accumulator.
ASTERISK, NET/GROSS KEY, NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Gross accumulator.
ASTERISK, UNITS KEY
This combination will enter the Test mode. The Test mode is used to conduct a test of all
display elements. The test consists of five (5) cycles, each lasting about one (1) second:
1. All horizontal segments will turn on (no annunciators).
2. All vertical segments and decimal points will turn on (no annunciators).
3. All annunciators will turn on.
4. All display elements off.
5. The model number (205, 210 ) and the software version X.X.
6. The calibration numbers (C1 to C4).
ASTERISK, PRINT KEY
This combination is used to
change
the selected print ticket format. Pressing the
ASTERISK
then the
PRINT
key will display a prompt “Prt=”. Press the
ENTER
key to
show the current value. If the setting displayed is acceptable, press the
ENTER
key
again to save it. Otherwise, using the numeric keys enter the new setting, then press the
ENTER
key to save it. Allowable values are:
0 = print tab settings 1 = Visual Print Format 1 2 = Visual Print Format 2
To Next Page
Loading...
Need help?
General
