What does notArE (no tArE) mean on Cardinal 200 Accessories?
If your Cardinal Accessories displays 'notArE', it means the NET key was pressed with no stored tare weight value. Determine the reason for the error display and take the appropriate corrective action.
What does ErrAh (Error Analog high) mean on Cardinal 200, and how to fix it?
If you see 'ErrAh' on your Cardinal Accessories, it indicates that the load cell input is above the range of the indicator. Check for improper load cell wiring, excessive load, and ensure the output is between 1 to 40mV. If the issue persists, it may be due to load cell or circuit failure.
What does ErrAL (Error Analog Low) mean on Cardinal 200 Accessories, and how do I resolve it?
If your Cardinal Accessories display shows 'ErrAL', it means the load cell input is below the range of the indicator. Check for improper load cell wiring and ensure the output is between 1 to 40mV. If the issue continues, it could be a load cell or circuit failure.
How to resolve incorrect weight displayed on Cardinal 200 Accessories?
If your Cardinal Accessories are displaying an incorrect weight, ensure the indicator has been calibrated. Also, check that the scale platform isn't touching any adjacent objects and inspect the load cell connector wiring. If you're using four-wire load cells, make sure the sense lead jumpers (J6 & J9) are installed. Finally, verify that proper operating procedures have been followed.
What does '-oF- (overflow)' mean on Cardinal 200 and how can I fix it?
If your Cardinal Accessories displays '-oF-', it means the indicator is attempting to display a positive number greater than six digits in length or a negative number of more than five digits. Return to Gross Weight mode and review the Tare value. This issue may also indicate miscalibration.
How to fix UnStb (Unstable) message on Cardinal Accessories?
If your Cardinal Accessories displays 'UnStb', it means there's motion present when trying to perform a print function. Wait for a stable weight display, indicated by the 'STABLE' annunciator being on, before proceeding.
What does it mean if Cardinal 200 says an invalid keypad entry was attempted?
If your Cardinal Accessories indicates that an invalid keypad entry was attempted, determine the reason for the error display and take the appropriate corrective action.
What to do if Cardinal Accessories display does not turn on?
If the display on your Cardinal Accessories doesn't turn on, check the following: Ensure the AC power cord is fully inserted into the wall receptacle. Verify the wall receptacle has proper AC power by testing it with another electrical appliance. Check the circuit breaker. Also, consider whether there has been a power failure.
What to do if Cardinal Accessories displays CALbtn?
If the 'CALbtn' is displayed on your Cardinal Accessories, release the switch. Ensure the correct screw (#10 x ½ Stainless Steel fillister head) was installed for the calibration access screw. Make sure the calibration switch cable is plugged into P7 on the PC board. You may need to replace the calibration switch assembly.
What does iiCErr (IIC bus failure) mean on Cardinal 200?
If your Cardinal Accessories displays 'iiCErr', it indicates an IIC bus failure. Press any key to continue.
General| Brand | Cardinal |
|---|---|
| Model | 200 Series |
| Category | Accessories |
| Language | English |
To Next Page
