Need help?Do you have a question about the Cardinal 748P and is the answer not in the manual?
General| Brand | Cardinal |
|---|---|
| Model | 748P |
| Category | Accessories |
| Language | English |
Manual describes installation, calibration, and operation of the Model 748P.
Important safety and operational warnings before using the instrument.
Control of external devices via preset weight comparator status.
Wiring instructions for optional relay board for AC powered devices.
Setting the interval value for the low range.
Setting the interval value for the high range.
Procedure for scale calibration using 'C' numbers or test weights.
Selection of units: Pounds, Kilograms, Tons.
Procedure for setting the first calibration weight (Zero or Test).
Procedure for setting the second calibration weight (Test or Zero).
Configuration for up to eight preset weight comparators.
Enabling and configuring the digital fill control feature.
Enabling and using the truck storage feature.
Selecting the compatible printer model for output.
Setting the baud rate for the bi-directional serial port.
Setting the parity for the bi-directional serial port.
Setting the position for printing consecutive numbers.
Setting the print position for gross weight.
Setting the print position for tare weight.
Entering calibration numbers for scale setup.
Adjusting the span of the scale.
Storing temporary truck IDs and printing tickets.
Adding or editing permanent truck identification numbers.
Description of the 12-bit analog output for weight representation.
Selection of Single Speed or Two Speed operation for fill control.
Operation filling one ingredient at a single rate.
To Next Page
