Cardinal 748P - Single Speed Digital Fill Control Operation

35
PERMANENT ID NUMBER USE
Step 1- Enter truck permanent ID and tare weight.
Press TRUCK
Enter ID number to be assigned
Press ENTER - display shows Sto=
Press ENTER to display value stored in memory or
scale weight
Press GROSS to enter the scale weight or key-in
value
Press ENTER - display shows ACC=
Press ENTER to show accumulator
Press ENTER to save or CLEAR to reset and press
ENTER
Repeat step 1 for all permanent trucks.
Step 2 - Process trucks as required.
Truck pulls on scale
Press ID
Enter ID number assigned to truck (see step 1)
Press PRINT
Printer records gross, tare, net and accumulated
new weights and ID number
NOTE! Regardless of whether the truck to be processed has a temporary or permanent
ID number, it is processed in the same manner: Press ID, key-in ID number, press PRINT.
SINGLE SPEED, EIGHT BIN (presets) DIGITAL FILL CONTROL OPERATION
This standard feature of the 748P fills one ingredient up to a Preset Target weight limit minus a
stored Trim weight. It can control relays to fill from eight seperate bins but it can only fill one material
at a time. Note that the Digital Fill Control feature must have been enabled during setup and
calibration of the 748P to be operational.
To start a fill operation:
1. With the indicator in the Gross Weight mode (the GROSS annunciator on), press the START/
STOP key.
2. The
BIN/PWC annunciator will turn on and the weight display will show bin=. Key-in the BIN
(preset) number and press the ENTER key.
3. The display will change to FiLL= , the prompt for the stored target weight. Key-in the target
weight and press the ENTER key. Note that the target weight is stored in non-volatile memory.
4. The display will change to tr= , the prompt for the stored trim weight, and press the ENTER
key. Note that the trim weight adjust automatically and, like the target weight, is stored in non-
volatile memory.
5. The display will change to StArt= , the prompt to start the actual fill operation. Press the 1 key
(1 = YES) to begin the operation, then proceed to step 7
or to abort the operation and start over,
press the 0 key (0 = NO).
6. The
BIN/PWC annunciator and the relay will turn on and the fill operation will begin.
7. The weight will increase to the preset value. When the displayed weight reaches the preset
value, the relay is turned off.
8. When all motion stops the weight will be printed (if a printer is attached) and the
BIN/PWC
annunciator will turn off.
9. The trim weight will be recalculated and stored in non-volatile memory and the displayed weight
value added to the BIN and GROSS or NET accumulators.
Inbound - empty or loaded
SCALE
Outbound - empty or loaded