Digital Fill Control II 748P Addendum
Page 6 of 6
OPERATION
TWO SPEED, A then B OPERATION (Cont.)
10. At the slow cut-off point (SLO=), the B relay will be turned off and the two bar
graph elements directly beneath Preset #2 will be turned off.
11. When all motion stops the weight will be printed (if a printer is attached) and the
BIN/PWC annunciator will turn off.
12. The Trim Weight will be recalculated and stored in non-volatile memory and the
displayed weight value added to the accumulators.
REMOTE START / STOP
This function has been added to the Digital Fill Control feature to start and stop a filling
operation. Using Optically Isolated Input pin number 2, the filling operation can be
remotely started and if already in progress, stopped. Remember that the input must be
connected to Gnd to initiate the function.
WARNING!! This feature is not to be used for an Emergency Stop
Button. It is to be used ONLY for remotely starting and stopping a filling
operation. Failure to observe this warning may result in serious injury
to the operator and/or other personnel.
To Next Page
Loading...
