NOTE: Selecting a CHANNEL that is already in use will replace the paired device on that CHANNEL with the newly paired headset.
NOTES:
• If the Pairing process is not completed within two minutes the units will return to Standby mode.
• When connected to a Solo, FM, TeamSet Pro or TeamSet Driver unit only Rider-to-Passenger mode is Available.
• When using a scala rider Solo, FM, TeamSet pro or a TeamSet Driver unit to serve as the Passenger unit, Voice Connect Intercom can only be
initiated from the G9. However, you can always initiate the Intercom manually also from the other scala rider unit by pressing the button.
THREE WAY INTERCOM WITH OTHER SCALA RIDER MODELS
In terms of range, the 3-Way Intercom between your G9 and other scala rider units achieves distances of the lowest common denominator. For
example, connecting your G9 with two Q2 pro units will enable intercom distances of maximum 2,300 ft / 700m.
NOTE: When connected to certain earlier scala rider headsets (e.g. a Solo, FM, TeamSet pro or a TeamSet Driver unit) only Rider-to-Passenger
mode is Available.
1. Pair G9 to 1
st
Unit: Choose Procedure A, B or C above depending on the type of Unit that you are pairing with the G9.
2. Pair G9 to 2
nd
Unit: (on a different CHANNEL) Choose Procedure A, B or C above depending on the type of Unit that you are pairing with the
G9.
INITIATING INTERCOM CALLS FROM OTHER SCALA RIDER MODELS TO A G9:
scala rider G4:
Use VOX or press CHANNEL A or B button
scala rider Q2 pro: Tap the MC Button once on a Q2 pro unit to open an intercom call. To end the call, tap once.
scala rider Q2: Tap the MC Button twice on a Q2 unit to open an intercom call. Wait 3 seconds between taps. To end the call, tap once.
Other scala rider models: Tap the headset CTRL Button to open/close intercom call.
To Previous Page
Loading...
Need help?
General
