Cardo Systems Scala rider Q-Solo User Manual

Q-solo
™
Manual
scala rider
®
Q-solo
1 INTRODUCTION
2 CHARGING THE SCALA RIDER
3 GETTING STARTED: 3.1 STATUS LIGHTS, 3.2 GENERAL FUNCTIONS, 3.3 VOX ACTIVATION
4 PAIRING AND USING A MOBILE PHONE, GPS DEVICE OR ANY MUSIC PLAYERS:
4.1 PAIRING BLUETOOTH , 4.2 MAKING AND RECEIVING PHONE CALLS, 4.3 LISTENING TO MUSIC VIA A2DP
5 TROUBLESHOOTING
6 SUPPORT
INDEX
IMPORTANT:
This is version 1.0 of the User
Manual. Please note, that our
manual is periodically updated
on the Cardo website to include
the very latest features and
functions of your new scala rider.
➊ ➋ ➌
➍
➎
➏
1. Power Button
2. LED Indicator
3. Music / Mobile Button
4. Volume Up
5. Charging
6. Volume Down
INTRODUCTION
Thank you for choosing the scala rider Q-solo Bluetooth® headset
for motorcycle helmets. This manual will help you set up, congure
and operate it.
1
CHARGING THE SCALA RIDER
Make sure that your scala rider is fully charged for at least 4 hours
before initial use.
Charging with a 5v wall charger is faster than charging with a
computer USB port.
• RED LED ON – Charging
• RED LED OFF – Charging complete
The scala rider Q-solo is waterproof and dustproof. However,
when in use, the USB silicone cover should be kept tightly closed
to prevent moisture from entering the unit.
2
GETTING
STARTED
3.1 STATUS LIGHTS
None scala rider is OFF
The BLUE LED ashes once every 3 seconds Standby mode. No active audio sources
The BLUE LED ashes twice every 3 seconds Active mode – Call in progress / music or other audio source is ON
The RED LED ashes once every 3 seconds Standby mode – Battery is low
The RED LED ashes twice every 3 seconds Active mode – Battery is low
Solid RED Charging
3

Cardo Systems Scala rider Q-Solo Specifications

General

Brand	Cardo Systems
Model	Scala rider Q-Solo
Category	Headsets
Language	English