Cardo Systems Scala rider Q-Solo User Manual

scala rider
®
Q-solo
3.2 GENERAL FUNCTIONS
Power ON / OFF
Press for 2 seconds
ON: 3 BLUE ashes + Ascending tone OFF: 3 RED ashes + Descending tone
Volume
Tap or to adjust and set volume of current audio source
Mute
Tap and simultaneously
Battery Check
In Standby, press for 2 seconds:
• BLUE LED = Full charge • PURPLE LED = Half charge • RED LED = Almost empty
3.3 VOX ACTIVATION
Your scala rider oers a voice operated feature for hands-free
operation.
Answer a call Speak any word loudly into the microphone
Reject a call Remain silent for about 15 seconds
4.1 PAIRING BLUETOOTH
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. Check the scala rider is in Standby mode (single LED ashes every 3 seconds).
3. Press for at least 5 seconds until the BLUE LED ashes once every 3 seconds
4. Search for Bluetooth devices on your phone/GPS/MP3 player by following the device’s
instructions.
5. After a few seconds the device will list “scala rider Q-solo ”. Select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The device will conrm that pairing has succeeded and PURPLE will ash for 2 seconds
8. If pairing is not completed within 2 minutes, the scala rider will return to Standby mode.
PAIRING AND USING A MOBILE PHONE, GPS DEVICE OR ANY MUSIC PLAYER
To connect your scala rider to a Bluetooth device you must rst pair them. Once paired, they will
automatically recognize each other whenever they are within range (10m / 33ft).
Your scala rider has Bluetooth channel for connecting to a mobile phone, GPS device
and a music player with A2DP.
NOTES:
• Not all Bluetooth mobile phones can broadcast
Bluetooth Stereo music (A2DP), even if the phone
has a music player function. Consult your mobile
phone’s User Manual for more information.
• Not all Bluetooth GPS devices allow connection to
Bluetooth audio devices. Consult your GPS User
Manual for more information.
• After pairing, you may need to tap to connect
the scala rider .
4.2 MAKING AND RECEIVING PHONE CALLS
Answer a call
Tap or say any word loudly to answer by VOX
Reject a call
Remain silent for 15 seconds, or press and hold for
2 seconds
End a call
Tap
Voice Dial*
(if supported by
mobile phone)
Tap and simultaneously and follow the prompt
from the mobile
Redial*
Press and for 2 seconds
*This feature is not available during mobile calls
4.3 LISTENING TO MUSIC VIA A2DP
Available only on compatible Bluetooth audio sources
Play In Standby, tap
Pause/Stop Press for 2 seconds
Next Track With music ON, tap
Previous Track* With music ON, double tap
*With some phones you may need to repeat this action
TROUBLESHOOTING
Reboot
If your scala rider stops responding, reset it by turning it o and then on again (press for 2 seconds).
Reset Pairing
(Deletes paired device)
1. In Standby, press for 5 secs until LED ashes RED/BLUE.
2. Press for 2 seconds until LED ashes 5 times in PURPLE.
Unresponsive Device Please connect to your charging cable for 30 seconds to allow the device to reset.
4
5
6
USA and Canada: 1-800-488-0363
International: +49 89 450 36819
CONTACT & SUPPORT
1
MAN00001 QG onlinesolo EN 001
support@cardosystems.com
cardosystems.com
www

Cardo Systems Scala rider Q-Solo Specifications

General

Brand	Cardo Systems
Model	Scala rider Q-Solo
Category	Headsets
Language	English