EasyManua.ls Logo

CARE CCSI300 - Electrical Requirements; Power Supply Cord; Installation Guide

Default Icon
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 5
SAFETY INFORMATION
ELECTRICAL REQUIREMENTS
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to t into a polarized outlet only one way.
If the plug does not t into the outlet, reverse the plug. If it still does not t, contact a
qualied electrician. Do not attempt to modify the plug in any way.
NOTE: This appliance requires a minimum of 1200 watts and it should be the only appliance
operating on the circuit.
NOTE: Neither Commercial Care nor the dealer can accept any liability for damage to the product
or personal injury resulting from failure to observe the electrical connection procedures.
POWER SUPPLY CORD
1. A short power supply cord is provided to reduce the risk of becoming entangled in
or tripping over a longer cord.
2. If the power supply cord is too short, do not use an extension cord. Have a
qualied electrician or serviceman install an outlet near the appliance.
3. If it is absolutely necessary to use longer cord sets or an extension cord, extreme
care must be exercised.
a) Use an extension cord rated no less than 10-amperes.
b) The marked electrical rating of the cord set or extension cord must equal to
or be greater than the electrical rating of the appliance. The longer cord should
be arranged so that it will not drape over the counter top or table top where it
can be pulled on by children or tripped over unintentionally.
NOTE: Neither Commercial Care nor the dealer can accept any liability for damage to the product
or personal injury resulting from failure to observe the electrical connection procedures.
INSTALLATION GUIDE
1. Make sure that all the packing materials are removed from the steam iron.
2. Check the steam iron for any damage. If there is any damage, do not operate the
steam iron. Contact the Customer Satisfaction Center, see page 13.
3. Make sure that the power supply cord is undamaged and does not run under the
steam iron or over any hot or sharp surface.
4. The receptacle used for power must be readily accessible so that the cord can be
quickly reached and easily unplugged in an emergency.