Page 9
BURST OF STEAM
This function provides an extra amount of steam to remove stubborn wrinkles.
1. Check the water level. Add water if needed.
2. Turn the temperature control to the position “MAX.”
3. The temperature operating indicator light turns off
when the required temperature is reached.
4. The iron is ready for use.
5. Press the Burst of Steam button once, .
6. Steam will penetrate into the garment removing the
wrinkles.
7. Wait a few seconds before pressing the Steam Burst
Button again when there are stubborn wrinkles.
VERTICAL STEAMING
To get better result when using vertical steam, hang
the garment on a clothes hanger. Curtains and drapes
may also be steamed once they’re hung. Hold the iron
away from your body, close to but not touching the
fabric. Pull the fabric tight with your free hand and
pump the Vertical Steam Button (Steam Button) at
2-5 seconds intervals as you pass the iron over the
wrinkled fabric.
ANTI-DRIP SYSTEM
When the temperature of the iron drops too low, the water chamber valve
automatically closes. This prevents hot water from spilling out through the vents of
the soleplate.
ANTI-CALC SYSTEM
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and does not need to be
replaced.
max
SET UP & USE
max
m
ax
To Next Page
Loading...