■ How to re-position the seat
The seat can slide backwards and forwards for a comfortable driving position. To slide the
seat,
pull the lever at the front of the seat and reposition as required.
■ Tiller Adjustment
The tiller can be adjusted into many different positions to suit
each driver.
1. Loosen the lever to adjust the tiller to the position you
require.
2. Once position is chosen, tighten the lever to secure the
tiller.
■ Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s battery becomes low,
or the scooter is heavily strained because of excessive
loads or steep inclines, the main circuit breaker may trip
to protect the motor and electronics from damage.
4.3 ASSEMBLING AND DISASSEMBLING
■ Assembling the Scooter
No tools are required to disassemble or assemble your scooter.
1. Place the freewheel mode lever in the drive position.
2. Set the rear section in the up position and make sure the hook for the front section is
connected to the axle of the rear section.
3. Put down the front and rear sections until the scooter is locked.
4. Set down the battery pack on the scooter, and make sure it is in the correct position.
To Next Page
Loading...
