What to do if LED lights indicate battery disconnected on CareCo ZOOM?
If the LED lights on your CareCo Scooter indicate the battery is disconnected, ensure the battery box is placed securely in the scooter and that all packaging has been removed. The issue may be caused by the battery not being connected or a poor connection to the battery terminals.
What to do if LED lights indicate speed selection dial faulty on CareCo ZOOM?
If the LED lights on your CareCo Scooter indicate the speed selection dial is faulty, try the speed limit dial in a different position, such as half speed or similar. This problem may be caused by broken or shorted speed limit pot wires or a broken speed limit pot.
What to do if LED lights indicate wig-wag lever/mechanism faulty on CareCo ZOOM?
If the LED lights on your CareCo Scooter indicate the wig-wag lever/mechanism is faulty, ensure the throttle lever is in the center position before turning the scooter on. This issue may be caused by a throttle input wire being open or shorted, a defective throttle pot, or the lever not being in the center at start-up.
What to do if LED lights indicate brake off fault on CareCo ZOOM Scooter?
If the LED lights on your CareCo Scooter indicate a brake off fault, check that the brake/freewheel lever is in the 'Drive' position before turning it on. This issue may arise if the electromagnetic brake driver is open or the electromagnetic brake coil is shorted.
What to do if LED lights indicate brake on fault on CareCo Scooter?
If the LED lights on your CareCo Scooter indicate a brake on fault, check that the brake/freewheel lever is in the 'Drive' position before turning it on. This issue may arise if the electromagnetic brake driver is shorted or the electromagnetic brake coil is open.
What to do if LED lights indicate HPD fault present >10 sec on CareCo ZOOM?
If the LED lights on your CareCo Scooter indicate a HPD fault present for more than 10 seconds, check the condition of the throttle lever and ensure that it is in the center before turning the scooter on. The cause may be a misadjusted throttle or a broken throttle pot or throttle mechanism.
What does it mean when LED lights indicate battery voltage too high on CareCo ZOOM?
If the LED lights on your CareCo Scooter indicate the battery voltage is too high, check that the charger is unplugged. This can happen if the voltage is over 31 volts, the vehicle is operating with the charger attached, or there is an intermittent battery connection.
What to do if CareCo ZOOM Scooter switches on but will not move?
If your CareCo Scooter switches on but won't move, ensure there is enough power in the battery and recharge it if necessary. Also, make sure the freewheel lever is engaged in the ‘DRIVE’ position.
Safety advice and user familiarity before operating the scooter.
Safety guidelines and restrictions during scooter operation.
Step-by-step instructions for starting, driving, and controlling the scooter.
Step-by-step procedure for safely and effectively charging the scooter's battery.
Common symptoms, possible causes, and remedies for scooter malfunctions.
General| Maximum Speed | 4 mph |
|---|---|
| Maximum Range | 10 miles |
| Ground Clearance | 6 cm / 2.3 Inches |
| Turning Radius | 145 cm / 57 Inches |
| Max Speed | 4 mph |
| Range | 10 miles |
| Type | Folding Mobility Scooter |
| Total Weight | 27.8 kg / 61.3 lbs |
| Weight | 27.8 kg / 61.3 lbs |
To Next Page
